Wednesday 6 August 2014

switch panel

I think i've mentioned previously that the switch panel I made was OK, but the switches have proved unreliable. Consequently, I needed a new panel.

I've designed one using some proper software, ready to accept some much better quality switches, and was about to hit the 'go' button when I bottled it, and decided to double check my measurements!

So that's another job to do once on board.... and as much as I was pleased with my hand engraved panel, a properly designed and machine engraved one will look very nice indeed.

Also, I've taken the opportunity to put proper resettable breakers on the panel, rather than the automotive spade fuses that I have currently got.... makes life a lot easier should one blow!

No comments:

Post a Comment